dynafor LLX2, Operation And Maintenance Manua

Page: 54 / 148

GB
18
6.2.4.7 Stopping the device
6.2.5 Error Messages
No radio reception
6.3 Advanced functions
This chapter presents the functions that enable advanced use of dynafor™ LLXh
See the general overview of the programme at the end of the manual.
6.3.1 MAIN Menu
6.3.1.1 Functions Menu
Confirm selection
Main Menu:
Select MENU.
Confirm with
Select the required sub-menu.
Confirm with
ESC
Return to standard display
without modification
Select an icon and enable the
available options
Select an icon and enable the
available options
Possible causes
Solutions
Sensor switched off or switched to the
standby mode (see 27)
Sensor too far from display unit
Network conflict
High electrical magnetic interference
Switch off display unit, switch on
sensor, switch on display unit.
Bring appliances closer together
Check network configuration
(see advanced functions section
6.3.2.4).
Display Action Comments
No action
Stopping the device:
Keep the ON / OFF button
depressed for 3 seconds to switch
off the display unit.
The sensor automatically moves into
standby mode, and will start up
again when the display unit is
switched on.
If necessary you can switch off the
sensor by pressing on the ON / OFF
button.
ESC
No action
Select an icon and enable the
available options
Select an icon and enable the
available options
Confirm selection
Functions Menu:
Select the required sub-menu.
Confirm with
ESC
Return to standard display
without modification
Select an icon and enable the
available options
Select an icon and enable the
available options
11
12
13
14