dynafor LLX2, Operation And Maintenance Manua

Page: 49 / 148

6.1.5 Turning on the display unit
The welcome screen is shown for 4 seconds, then the standard display window is shown.
6.2 Elementary functions
This chapter presents the functions that enable elementary use of dynafor
™
LLXh.
6.2.1 Keypad function limitation
This function is used to limit access to the advanced functions of the display unit.
In «Limited» mode, only the three basic functions are accessible: UNITS, TARE, MAX.
In «Full access» mode, all the functions are accessible.
Transition from one mode to another is achieved by a sequence of buttons on the front panel of the
display unit.
This function facilitates use of the LLX2 System by the operator while eliminating the risk of an
inadequate operation due to certain parameters being changed.
6.2.1.1 Deactivate «Limited» mode :
Press the ESC key when the display unit is switched off.
The next time the display unit is powered up, the MENU icon will appear in the upper left corner of the
screen in place of the icon representing a key.
6.2.1.2 Activate «Limited» mode:
Press the ESC key when the display unit is switched off.
The next time the display unit is powered up, an icon representing a key will appear in the upper left
corner of the screen in place of the MENU icon.
LIMITED mode FULL ACCESS mode
13
Sensor
Identification
Date of last
metrological
check
Metrological
check
Link locked
ON / OFF (3 sec) Current time Current date
Radio
channel used
A
GB