71
/
102
SM-8 Ev3/08072015
Neutral position adjusting:
-
Lift or support the machine so that the wheels are off the ground and can turn freely
-
Connect the main battery, first +
-
Start the mower – CAUTION! you can start the mower when the green neutral light is shining and the
engine brake is engaged (position near the frame)
-
After starting increase the drive speed slowly and put it back to the neutral position
-
If the mower is creeping, the electronical neutral is over the neutral limit of the pump valve, you can adjust
real neutral position by a special software SpiderMiniConfig – see
Programming of the control unit
, or
use a special procedure of the remote controller (adjustment of the neutral position by steering joystick) see
below
Adjustment of the neutral position by steering joystick
1) Activate
programming
mode
Set all proportional controllers to zero position.
Release the
EMERGENCY STO
P switch and wait till the radio
connection ispresent. Press and hold the
"1"
and
„1”
buttons
(directly left and right of theemergency stop switch) for 5 seconds.
Do NOT press the „HORN/ENABLE“ button!
2) Adjust the ZeroPos
value
Standard value is 127 (SW SpiderMiniConfig).
To adjust the value you need the joystick on the right side
(left/right).Each time you push the joystick to the left, the value will
decrease the value by one. Pushing it to the right will increase the
value by one. Each time you move the joystick to left or right, the
horn will acknowledge the movement.
N
