38
/
102
SM-8 Ev3/08072015
-
Remove blade hub from the crank shaft
-
For removing use the original bolt UNF ¼-30 and bearing puller
-
Press out the bearing 6305 2RS
Mounting: (Take the above steps in reverse order)
-
Loctite all bolts with LOCTITE 243
-
No need to adjust the clutch, check only the distance between the clutch and the blade hub. When the blade
is engaged there should be about 1 mm gap. If the gap is insufficient, and both pieces are touching each
other, replace worn parts of the clutch (clutch plate)
