Dürkopp Adler 667 PREMIUM, Service Instructions Manual

Page: 88 / 150

Programming
86 Service Instructions 667 PREMIUM - 03.0 - 01/2018
Mode
Setting defining which puller roller is supposed to run.
Mechanic
Both rollers freewheel passively; mechanical coupling only
Top+Bot
Both wheels run actively under power
Upper
The upper roller runs actively under power
Transport
Transport mode of the rollers
constant
Even transport
intermittent
Transport adapted to the rhythm of the machine's feed dog
Setting of the start and stop angle under
Start/Stop
has been
adapted to the machine. The values should not be changed.
Pressure
Set the puller pressure
Yes
Pressure is supplied constantly and regulated via the gage at the puller.
HPNo
Pressure is generated actively except for the 2nd stroke height.
No
No active pressure from puller.
SwitchOff
Puller is not active when the sewing motor is stopped. Holding force of the
roller is off; sewing material can be pulled out from between the rollers.
AlwaysOn
Puller is always on even when raised.
Top
Settings of the upper puller roller.
Transm.
Transmission, puller
(Value range 00.0 – 65.0)
Drive
Motor current, puller
(Value range 0.0 - 5.0 [A])
Hold
No-damage current, puller
(Value range 0.0 - 5.0 [A])
Diameter
Diameter, roller
(Value range 0000 – 9999 [mm])
Direction
Rotational direction, roller
0 = right
1 = left
ClosedLoop
0 = non-regulated (controlled operation)
1 = regulated
Bottom
Settings of the lower puller roller - identical to the settings of the upper
puller roller.
Menu item Setting options