Dürkopp Adler 667 PREMIUM, Service Instructions Manual

Page: 85 / 150

Programming
Service Instructions 667 PREMIUM - 03.0 - 01/2018 83
14.6.10 Setting the Motor holding force (
Holding Force
) parameter
Various settings can be made for the holding force of the motor. The pos-
sibilities are explained in more detail in the table.
BRM
Bobbin rotation monitor
(Value range: On/Off)
Stitches
Delayed stitches before the bobbin rotation monitor starts. The machine
calculates the number of stitches automatically depending on the value
entered.
(Value range 000 – 255)
MsgAfterTrim
If detecting an error during the enlacement check or while monitoring
the bobbin rotation, the machine will indicate an error message during
the seam, which must be confirmed with
OK . The error disappears.
If the parameter
MsgAfterTrim
is active, the error will be displayed
again after the seam has been completed.
(Value range: On/Off)
StopConfirm
If detecting an error during the enlacement check or while monitoring
the bobbin rotation, the machine will indicate an error message and
stop. You must confirm this error before you can resume sewing.
(Value range: On/Off)
Menu item Setting options
Menu item Setting options
Mode Off
Holding force inactive
On
Holding force active
Hold Pos.
Position control; position is checked and resets itself
Max.Current
Holding current of the motor
(Value range 00 – 50)
Response
Response time for the continuous current
(Value range 000 – 100)