© 2006 Carlo Gavazzi Industri A/S. All rights reserved
59
G 3800 X036 Operation Manual
August 2006
Door lock
The Door Lock armoring operates like a push-button, and when
armouring:
activated the Intruder alarm system is started.
The Door Lock armouring must be kept active as long as the
alarm system should be running.
The Door Lock armouring prevents the alarm-detectors to react
upon their respective disable addresses. The Door Lock
armouring thus activates all alarm zones.
Code lock
The Code Lock armouring operates like a toggle switch and is an
armouring:
an alternative way to start and stop the Intruder alarm system.
The Code Lock armouring also prevents the alarm-detectors to
react upon their respective disable addresses.
Like the Door Lock, the Code Lock activates all alarm zones.
Note: Either Code Lock or Door Lock may be used at one time.
Alarm siren:
The Alarm siren is used for the local audio alarmsignal. The
Alarm sirene, also supports 'Visual' effects, as a selection of
addresses may be set up to flash while the siren is on. This
feature will further stress any intruder
Silent Alarm signal:
The “Silent Alarm signal” is primarily intended for sending an
alarm signal to a security centre. Equally important is, that when
this signal has been sent, the Intruder alarm system resets the
detected alarms, and the surveillance cycle on the detectors is
restarted.
Warning signal:
This is an output for a local buzzer or lamp. When the alarm is armed,
the Warning Signal will start pulsating slowly and increase pulse-
speed until alarm is armed. For this function to operate properly, the
armouring delay should be set to a minimum of 10 seconds.
Toggle switch
Has an option for sending signals to Intruder alarm. See the chapter
func-
tion:
describing the Toggle Switch function.
Motion detector:
The motion detector can also be integrated in the intruder alarm.
See the chapter describing the Motion detector.
Parameters
Parameter
Description
Passive detector
Disable address
Enter an address or a flag whose activation (“1”-signal) will prevent the
detector to cause an alarm. This feature may be used to have more alarm
zones, when the alarm is armoured by the Manual Armouring.
