Oil change
This mode of “Parameter and level change menu”
displays the selected parameter and the relevant level
currently set, and it is possible to set a new level
among the available values.
Parameters for which it is possible perform the quick
change are the following:
●
DTC (from level 1 to level 8)
●
DWC (from level 1 to level 8)
●
DSC (from level 1 to level 2)
●
EBC (from level 1 to level 3)
In “Parameter displaying” mode, when one
parameter listed above is displayed, press button (5)
to enter level quick change mode.
The parameter is displayed inside the menu on the
left side and it is possible to select the desired level
using button (6)
and button (7)
.
For example, if the parameter for which you wish to
carry out the quick level change is “DTC” and the
current level is “5”:
-
each time you press the button (7)
it
decreases by one level until reaching level "1";
-
each time you press the button (6)
it
increases by one level until reaching level "8".
The level displayed is immediately set by the
instrument panel for the concerned parameter.
Note
Through the quick change it is not possible to
disable the parameter by setting an “off” level.
Press button (5)
to go back to “Displaying of
parameters and relevant values” mode.
DTC 5
6
4
6
7
5
Fig. 21
55
Summary of Contents for PANIGALE V4
