Ducasa Colorado DGi+ 450, Manual

Page: 12 / 20

12
OFF
ON
Open Window
Wed. 11:00h
21
.5°C
Set point:
OFF
ON
Self Adaptive
OFF
ON
EASY mode
OFF (100%)
75%
50%
20%
LowSurfaceTemp
Wed. 11:00h
21
.5°C
Set point:
COMFORT
EASY
set temp
21
.5°C
Set point:
Wed. 11:00
Status ON
Change
Password
Runback Config
Setback
Max. Temp.
Runback
Confirm
OK CANCEL
RESET
LST 23%
Wed. 11:00h
21
.5°C
Set point:
The Open window setting
will turn the heating of the
towel rail off if the unit detects
a rapid drop in temperature
over a short period of time.
To re-activate the heating
if the open window function
has activated press any
button the towel rail.
If the temperature rises
above the minimum detected
temperature then the heater
will reactivate and turn the open window function
off (i.e. the window was closed).
If this function comes on frequently e.g. in an
area where there is an external doorway, it is
recommended to turn the open window function
off. To turn on/off use the +/- buttons and confirm
with Mode/OK .
The Self Adaptive setting
will allow the towel rail to
calculate the optimum time
to start the heating cycle
when running in Program
mode.
If this setting is turned
on it will be shown in the
Notification area and the
heating will come on before
the programmed starting
time so that the room is at
the correct temperature at
the programmed starting time. To turn on/off use
the +/- buttons and confirm with Mode/OK .
The Low Surface
Temperature (LST) menu
will allow the output of the
heater to be limited to a
lower setting to prevent
the surface of the heater
becoming too hot.
It is recommended that if
the LST function is activated
then the towel rail should be
locked with a non-standard
password after activation to
prevent the function being
turned off.
(See Password Section for details on changing
the factory default password).
To cycle between the different outputs use the
+/- buttons and confirm the selection with Mode/
OK.
EASY Mode is a simple
mode of operation where
by only the + and – buttons
on the towel rail operate to
increase or decrease the
temperature. The Mode/OK
button is de-activated.
When running in Easy
mode the screen will show
EASY in the notification area
to let the user know that the
mode is active.
To exit EASY mode press
and hold the CONFIG button
for 10 seconds, then select
“off”, using the +/- button
and confirm by pressing
Mode/OK.
Runback: See Runback
Section on page 14
Password: See Password
Section on page 14
Resetting the towel rail
will return all settings to the
factory defaults and will also
delete any ‘pairing’ with a
Gateway.
To activate the RESET feature select “OK” using
the +/- buttons and then press the Mode/OK
button to confirm.
The first press of any button will wake up the towel rail any further
button presses will activate the function required.