6
A
G
B
H
F
C
D
E
COMPONENTS
The components for fastening the towel rail to a wall are supplied in a bag together with the appliance.
There are four support assemblies, each consisting of the following components:
(A) 1 plastic tube Ø28 x 65mm + screw M5
(B) 1 plastic tube Ø20 x 55mm with threaded inserts
(C) 1 screw M6
(D) 1 plastic retainer (conic 15º)
(E) 1 plastic cap
(F) 1 screw Ø3 x 10mm
(G) 1 screw Ø6 x 50mm
(H) 1 nylon stopper Ø10mm
MOUNTING
The towel rail is fixed to the wall by four support assemblies. Two support assemblies should be positioned
between the 2
nd
and 3
rd
horizontal tubes from the top and two between the 2
nd
and 3
rd
horizontal tubes from
the bottom.
STEP 1
First, the 4 supports are placed on the towel rail, take a piece (B), fix the piece (D) with the screw (C) and
insert it between two tubes from the front, taking care that the conical part of parts (B) and (D) faces inside
the appliance. Repeat this in all four support positions.
STEP 2
Once the brackets are attached to the appliance, check their position and mark the 4 support points on the
wall. Drill the holes in the wall and insert the plug (H).
STEP 3
We take part (A), insert the screw (G) and fix it on the wall plug.
Insert part (B) into part (A) and fit the screws (F), do not tighten them.
STEP 4
Once all the supports are in place, place the covers (E) on the piece (D).
Check that the towel rail is in a perfectly vertical position and tighten the screws (F).
Summary of Contents for Colorado DGi+ 450
Page 18: ...18 NOTES...
Page 19: ...19 NOTES...
