Ducasa Colorado DGi+ 450, Manual

Page: 8 / 20

8
Wednesday
11:00
21
.5°C
Wed. 11:00
Set point:
COMFORT
Wed. 11:00h
21
.5°C
Set point:
COMFORT
21
.0°C
Set point:
OK
ECO
18
.0°C
Set point:
OK
ANTI-FROST
7
.0°C
Set point:
OK
21
.5°C
Wed. 11:00
Set point:
COMFORT
CONFIG
COMFORT
ECO
ANTI-FROST
PROGRAM
SETTINGS COMFORT
TIME
DATE
DST
TIME SETTINGS
CONFIG
COMFORT
ECO
ANTI-FROST
PROGRAM
SETTINGS
COMFORT
TIME
Settings
DISPLAY
Settings
ADVANCED
Settings
SETTINGS
USING IN OPERATING MODES
To assist with programming the TFT screen is
backlit and will stay illuminated for approximately
10 seconds after the last button is pressed. (To
change the backlight time, see the section on
DISPLAY)
When the towel rail is operational and the room
temperature is lower than the set temperature the
heating symbol will be shown indicating that
the towel rail is producing heat.
The following screens show MANUAL , AUTO
and OFF modes. To scroll between MANUAL and
AUTO press Mode/OK button.
To enter and exit OFF mode press the ON/OFF
button. When OFF mode is exited, it return to the
mode used prior to entering OFF mode.
When the towel rail is in MANUAL mode the
temperature can be adjusted by pressing the +/-
button. The towel rail will regulate the room to the
chosen set temperature.
When the towel rail is in AUTO mode the
temperature can be adjusted by pressing the +/-
buttons. This change will remain active until either
the next programme change or until midnight when
the temperature will revert to the preset value.
When the temperature has been adjusted in
AUTO mode a hand will show beside the auto to
symbol to show the amended set-point.
To return to AUTO mode press the Mode/OK
button.
NOTE: To rapidly change the temperature set-
point in any mode press and hold the +/- keys.
SET AUTO TEMPERATURES
To amend the temperature set points used in the
AUTO mode, press and hold the CONFIG button
until the following screen appears:
Select either Comfort, Eco or Anti-Frost by using
the +/- button and press Mode/OK to enter the
menu.
Press the +/- button to change the temperature
of each mode then press Mode/OK to confirm
and return to the main operation screen, repeat
the above to set the other program temperature
set-points.
SETTING THE TIME AND DATE
If a towel rail is paired with a Gateway then the
local time from the internet is automatically applied
to the towel rail.
To set the Clock on an unpaired Towel rail, press
and hold the CONFIG button until the CONFIG
menu is shown and then select SETTINGS using
the +/- button, press Mode/OK and then select
TIME Settings using the +/- button and press
Mode/OK again.
In the TIME menu the
Time, Date and Daylight
Savings (DST) can be set.
These can be selected by
pressing the +/- button.