VigorPro5510 Series User’s Guide
57
Enable
Check this box to enable such port redirection setting.
Mode
Two options (Single and Range) are provided here for you to
choose. To set a range for the specific service, select
Range
. In
Range mode, if the public port (start port and end port) and the
starting IP of private IP had been entered, the system will calculate
and display the ending IP of private IP automatically.
Service Name
Enter the description of the specific network service.
Protocol
Select the transport layer protocol (TCP or UDP).
WAN Interface
Chose the WAN interface for applying port redirection. The default
setting is
All
which means all the incoming data from any port will
be redirected to WAN1 and WAN2 at the same time.
Public Port
Specify which port can be redirected to the specified
Private IP
and Port
of the internal host. If you choose
Range
as the port
redirection mode, you will see two boxes on this field. Simply type
the required numbers on these two boxes.
Private IP
Specify the private IP address of the internal host providing the
service. If you choose
Range
as the port redirection mode, you will
see two boxes on this field. Simply type the IP address in the first
box (as the starting point). The second one is assigned
automatically after you type the private port number below.
Private Port
Specify the private port number of the service offered by the
internal host. After you enter the proper number in this box, the
second box of Private IP address will be assigned accordingly.
Active
Check this box to activate the port-mapping entry you have
defined.
Note that the router has its own built-in services (servers) such as Telnet, HTTP and FTP etc.
Since the common port numbers of these services (servers) are all the same, you may need to
reset the router in order to avoid confliction.
For example, the built-in web configurator in the router is with default port 80, which may
conflict with the web server in the local network, http://192.168.1.13:80. Therefore, you need
to
change the router’s http port to
any one other than the default port 80
to avoid
conflict, such as 8080. This can be set in the
System Maintenance >>Management Setup
.
Summary of Contents for VigorPro 5510 Series
