Draytek Vigor2850 Series, User Manual

Page: 98 / 387

Vigor2850 Series User’s Guide
88
3
3
.
.
2
2
.
.
2
2
G
G
e
e
n
n
e
e
r
r
a
a
l
l
S
S
e
e
t
t
u
u
p
p
This page provides you the general settings for LAN. Click
LAN
to open the LAN settings
page and choose
General Setup
.
There are four subnets provided by the router which allow users to divide groups into different
subnets (LAN1 – LAN4). In addition, different subnets can link for each other by configuring
Inter-LAN Routing
. At present, LAN1 setting is fixed with NAT mode only. LAN2 – LAN4
can be operated under
NAT
or
Route
mode. IP Routed Subnet can be operated under Route
mode.
Available settings are explained as follows:
Item Description
General Setup-----
Allow to configure settings for each subnet respectively.
Index -
Display all of the LAN items.
Status-
Basically, LAN1 status is enabled in default.
LAN2, LAN3, LAN3 and IP Routed Subnet can be
observed by checking the box of
Status
.
DHCP-
LAN1 is configured with DHCP in default. If
required, please check the DHCP box for each LAN.
IP Address -
Display the IP address for each LAN item.
Such information is set in default and you can not modify it.
Details Page -
Click it to access into the setting page. Each
LAN will have different LAN configuration page.
Each
LAN must be configured in different subnet.
IPv6 –
Click it to access into the settings page of IPv6.
Inter-LAN Routing
Check the box to link two or more different subnets (LAN
and LAN).