DRAGON WINCH DWH 12000 HD, Operation Manual

Page: 43 / 218

43
www.dragonwinch.com
Connecting the wired control of the winch
The wired control has three wires: red
F
and two other,
terminated with connectors: blue g and black i .
1. Connect the red
F
wire of the
a
pin on the relay
2. Connect the blue g wire with the h connector of the
relay
3. Connect the black i wire with the J connector of the
relay
G. CONNeCTION RADIO CONTROL FOR WINCH MODeLS:
dwM 000 sT
dwM 500 sT
dwM 3500 sT
Connection diagram - see section G at the end of the
manual.
Connect the wireless control as follows:
a. Connect the
red i
wire to relay pin marked with
a
.
b. Connect the black J wire to relay pin marked with B ,
and the other end (slide) to the control pin marked with .
c. Connect the white K wire to the relay control pin
marked with
3
.
d. Connect the yellow L wire to the control pin marked
with .
H. FOR WINCH MODeLS:
DWM 2000 YP, DWM 2500 YP AND DWM 3500 YP
FOLLOW THe DIAGRAM H.
The winch is controlled using a wired remote control that
already has a built-in relay.
iMPorTanT
1. Make sure that the electrical connections were
made correctly for your winch model.
2. The battery must be in a good condition.
3. Make sure that the electric cables are caught by
moving parts of the winch or vehicle.
4. Check the connections and the cables for dama-
ge regularly.
5. Tarnished or rusty wires reduce the efficiency of
the whole system.
6. All connections must be kept clean, which will
positively impact on their life and efficiency.
i
There are four wires coming out of the remote casing:
- two longer in red and black wires:
a
and
b
- two shorter red and black wires: a’ and b’
Connect shorter
a’
and
b’
wires to the motor, red one to the
„+” pin of the motor, and the black one to the „-” pin.
Connect the longer wires to the battery, red one to
„+”
and
black one to „-”
Using ThE winch
Pulling another vehicle or cargo
If you use the winch to pull another vehicle or cargo, put the
vehicle hand brake on and put stop blocks under wheels.
gB
! aTTEnTion
Do not confuse the cables with different length of
the wires. Connecting a long and a short cable to
the motor or battery can damage the relay and the
battery.