Dräger Savina, Instructions For Use Manual

Page: 20 / 132

Operation
20
To activate the ventilation mode
1 Hold down the appropriate ventilation mode key for about
3 seconds
or
1 Briefly press the appropriate ventilation mode key
3 confirm = press the rotary knob
The new ventilation mode selected is now operative.
Ventilation always starts with the last settings.
To set parameters for another ventilation mode
1 Press the key for the new ventilation mode briefly.
The yellow LED will flash.
2 In the block of parameter keys, the LEDs for the additional
parameters relevant to the new ventilation mode will start
flashing.
Constantly lit parameter keys indicate ventilation parameters
that are operative in the active ventilation mode. Any change
and confirmation of these parameters immediately affects the
active ventilation mode.
2 Press the relevant parameter key which has its LED
constantly lit.
3 Set the desired value = turn the rotary knob,
confirm value = press the rotary knob,
the yellow LED for that parameter key will go out.
3 To activate ventilation mode = press rotary knob.
If parameter setting is interrupted, Savina does not reset the
parameters set and confirms back to the old value.
To protect the settings against modification
4 Press » Lock « key; the yellow LED will light up.
The parameter keys, the ventilation mode keys and the
screen settings are now protected against alteration.
Before setting a new value:
4 Press » Lock « key. The yellow LED will go out.
005 3
7
2
6
1
D
Savina
3
1
2
0
1
5 3
7
2
6
1
D
Savina
4