Douwe Egberts Cafitesse 50, Service Manual

Page: 9 / 106

Installation -1
Version 1.36
02/2004
2. Unpacking and installation
2.1 Installation requirements
• Required tools
- Tools to make the required water connections, if applicable.
- A service device is needed to adjust set volumes, coffee strength, device calibration, etc.
- To remove covers a Pitcher torx no.10 (left, right, rear side cover) and no.15 (tank lid/inlet valve) is required.
• General requirements
Please ensure that the following requirements are met before you install the machine.
Ambient temperature : 1 - 32 °C / 50 - 90°F
Humidity : up to 80 % RH
Power supply : Europe : 230V/10A Europe / Japan :100V/12A / USA : 120V/15A
Determine the capacity of the electrical circuit before the machine is connected to
prevent overload. (min. spare capacity depending on version) It is recommended to
connect to an electrical circuit equipped with a fault current safety switch.
The machine must be connected to a grounded outlet conform regulations.
Water supply : Water pressure allowed: Min. 0.8 bar dynamic pressure/ Max. 10 bar static pressure.
(fixed water connection) Please measure in case of doubt.
Always operate in compliance with local regulations.
Location : Avoid direct exposure to hot or cold air, vibration and excessive amounts of dust.
Do not install the machine in the immediate vicinity of a stove or sink
to avoid extreme temperatures or humidity.
Place the machine on an even stable surface capable of supporting the weight
of the machine (approx. 19 Kg.) and beyond the reach of small children.
The location should allow proper access for operation and maintenance
of the machine as well as enough space behind the machine for ventilation.
Machine dimensions / space requirements
560 mm
22”
325 mm
12.8”
360 mm
14.2”
600 mm
23.6”
recommended clearance
around the dispenser :
120 mm/4.7”