Douwe Egberts Cafitesse 50, Service Manual

Page: 67 / 106

Functions (Cooling) - 3
Version 1.36
02/2004
D. Disassembly of the complete cooling unit
The cooling compartment must be disassembled to reach the dosing coil (see also 5C) or in case the
cooling compartment itself has to be replaced.
1. Close the faucet and remove the external
water supply hose. (water inside!) [
1 ]
Pour a cup of hot water. [ 2 ]
2. Unplug the power cord.[ 3 ]
3. Remove the tank lid.[ 4 ]
4. Disconnect the silicon water hose [ 5 ] as well
as the wiring [ 6 ] from the inlet valve.
5. Remove the retaining screw of the tank [ 7 ]and
lift the tank from the machine. (Guide wiring
and hose upright trough the opening in the
tank.) [
8 ]
6. Remove all machine covers (left cover, right
cover, rear cover and top cover) and water
tank.
About removing the right cover:
- Remove the screw at the rear side.
- Lift the cover about 12 cm /4”.
- Disconnect the flat cable of the On/Stand by
switch on the control PCB. (lower left corner)
- Lift the cover from the machine.
7. Disconnect the connectors CN8, CN9, CN13 &
CN14 on the control PCB.
CN8
CN9
CN14
CN13
In case a fixed water connection is installed
start from step 1.
If no fixed water connection is installed, unplug
the power cord and proceed with step 6.
1
3
2
4
5
6
7
8
Right cover
Rear cover
Top cover
Left
cover