Douwe Egberts Cafitesse 50, Service Manual

Page: 13 / 106

Installation -5
Version 1.36
02/2004
3. Depending on the version you are installing, proceed with 3a for machines with a removable water
tank or 3b for machines with a fixed water connection.
3a. Fill the cold water tank.
(Check if the sieve inside the tank is correctly placed over the water outlet)
Fill the cold water tank
Sieve
Outlet
Inst
all W
ater stop valve, filter and hose
3b. Confirm that the installation conditions are met for usage of the fixed water connection.
Important
- Ensure that the installation conditions are met before you install the fixed water connection. (see page 1)
- Always observe local regulation regarding plumbing!
- Water pressure allowed: Min. 0.8 bar dynamic pressure/ Max. 10 bar static pressure
- Make sure that the caution label indicating these pressure values is in clear sight after installation.
1. Connect the water stop valve to the faucet.
2. Connect the flexible water hose to the machine. (Do not forget to put the sealing ring in place!)
3. Flush the water filter. The necessity of this is depending on the type of filter used. Refer to the
manufacturer instructions.
4. Connect the water filter inlet hose to the water stop valve.
5. Connect the flexible water hose to the water filter.
6. Open the faucet to fill the water filter and the hoses.
7. Loosen the connection between the flexible hose and the inlet valve a little to allow air to escape from the
hose. Reconnect firmly afterwards.
1
2
3
6
4
5
7
1
2