ED700
Low Energy
Automatic Swing Door
DORMA
23
DORMA AUTOMATICS, Inc.
924 Sherwood Drive
Toll-Free: 877-367-6211
Lake Bluff, IL 60044
Fax: 877-423-7999 DL3038-010 Rev. B
6
/08
E-mail:
Subject to change without notice
HOLD OPEN
ON
OFF
Operation Instructions
1. Program Switch
Restart after power failure
When the power is turned ON, the ED700 goes back to
normal operation.
2. Care and Maintenance
Prior to first use and periodically thereafter, but at
least once a year, the system must be checked and
maintained by a qualified, knowledgeable technician.
During the cleaning operation the Program Switch
must be either in the OFF or HOLD OPEN position to
avoid automatic movements of the door wings.
Always disconnect the appliance before servicing.
The entire swing door assembly (Aluminum, Glass,
Covers) can be cleaned with a moist towel and
common commercial cleaners. The safety sensors are
to be cleaned with a dry, soft, non-abrasive towel.
The floor area near the swing door panel, including
the threshold must be kept clean.
3. Self Help Troubleshooting of Problems
If the door does not open or close, check the
following:
- Is the line power in order?
- Is the Program Switch in the proper position?
- Is the safety sensor path clear and clean?
- Is the door blocked by obstacles?
If all of the above check out OK call a qualified Service
Technician.
Technical Data
ED700 MUST BE SET UP WITHIN THE
BHMA/ANSI 156.19 STANDARDS
Switch is in position:
Continuous Open Operation
The door opens to the full opening
position and remains in this
position.
When an activation signal is
detected from the knowing act
activation device the door opens to
the full opening position. After the
hold open delay expires the door
closeses.
The door stops immediately when
the switch is placed in this position
and closes slowly under spring power.
The closing speed is limited. The
user may open the door manually.
HOLD OPEN
ON
OFF
