Dorma ED700, Installation And Tune In Manual

Page: 19 / 26

ED700
Low Energy
Automatic Swing Door
DORMA
19
DORMA AUTOMATICS, Inc. 924 Sherwood Drive Toll-Free: 877-367-6211
Lake Bluff, IL 60044 Fax: 877-423-7999 DL3038-010 Rev. B
6
/08
E-mail: automatics@dorma-usa.com
Subject to change without notice
Customized Set-Up
The purpose of the customized set-up is to change the
default ED700 settings. This can be done during or
after a completed learn cycle.
Parameters
•
Open speed to Back-Check
• Back-Check angle
• Deceleration through Back-Check
• Back-Stop angle
Open Speed to Back-Check (example)
• Close Delay
• Closing speed to Latch-Check
• Latch-Check angle
• Turn selector knob to “OPN SPD”.
• Turn the dial knob to select the desired speed
in DEGREES/SECOND.
• The display will show the code and
value.
• Using the example to the right and the table below,
make parameter changes as desired. When finished,
return the selector knob to “RUN”, or do another
“LEARN” Cycle if the door’s motion has been poorly
affected.
Open Speed
Opening speed to Back-Check
/s
Back-Check
Back-Check angle °
Back-Speed
Opening speed to Back-Stop, or Off /s
Back-Stop
Back-Stop angle
Hold Open
Delay
Time at Back-Stop
s
Close Speed
Max closing speed to Latch-Check
/s
Latch-Check
Latch-Check angle
°
°
°
°
°
increment/decrement
increment/decrement
increment/decrement
increment/decrement
increment/decrement
increment/decrement
increment/decrement OPN SPD
BCK-CHK
BCK SPD
BCK STP
HOLD
OPN DLY
CLS SPD
LCH-CHK
Selector
Code
Meaning
“Dial” Knob Function
DISPLAY
UNITS
• For further Set-Up options contained in “MONITOR”,
“MON SEL”, “MISC ADJ”, and “MISC SEL”, please
pages 27 and 28 for parameter details.
To adjust parameters in Miscellaneous selections turn the
selector knob to “MISC SEL” and select the desired
parameter, then turn the selector knob to “MISC ADJ”
and adjust the parameter using the dial knob.
To select the function to be monitored turn the dial to
“MON SEL” then select the function using the dial knob.
Then turn the selector knob to monitor.
RESETTING THE CONTROLLER
• To RESET the controller, turn the selector knob to “MISC SEL” and turn the dial knob until “rst” is displayed.
Now turn the selector knob to “MISC ADJ”, and turn the dial knob from “ON”, ONE click clockwise to “OFF”.
The controller has now been reset.
Once adjustments are completed verify that a learn cycle is not required by turning dial knob to
learn. If learn cycle is not required turn dial to “RUN” and turn program switch off and on.