ED700
Low Energy
Automatic Swing Door
DORMA
11
DORMA AUTOMATICS, Inc.
924 Sherwood Drive
Toll-Free: 877-367-6211
Lake Bluff, IL 60044
Fax: 877-423-7999
DL3038-010 Rev. B
6
/08
E-mail:
Subject to change without notice
Power the Operator to Hardstop
•
Turn mode switch from “OFF” to the “ON”
position.
ON
OFF
•
The operator pinion will now begin turning slowly
in the open direction, and stop indefinitely at the
hardstop.
•
When installation procedure is complete, turn the
mode switch to the “OFF” position to power down
the operator and close the door.
•
Connect the arm to the operator pinion with the door
opened to 5 degrees beyon the desired fully open position.
Basic Requirements
•
All cables are connected.
•
Swing area is clear of obstacles
•
Mode switch in position "OFF".
•
Power connected.
Start-Up
•
Turn selector knob to “LEARN”.
•
The display will read “ALL”.
The purpose of this feature is to drive the operator
to the fully-open hardstop. It is also used to load the
operator spring during the installation.
Using the Controller to Power the Operator to Hardstop
Lightly tighten SCREW in power arm with 9/16”
socket wrench to keep from falling off.
SYNC
TXD
GND
RXD
PGM
ENC
Breakout
Power the operator to the fully-open hardstop. (see controller instructions below)
Place the Main Arm on the Drive Shaft in the fully-open position.
THIS OPERA
TOR CONTROLLER MUST BE
ADJUSTED
TO MEET ANSI ST
ANDARDS
BY DORMA TRAINED PERSONNEL
MICROPROCESSOR CONTROL
115 VAC 60 Hz 2A
DORMA AUTOMATICS
Phone: 877-367-6211
Motor: 4A slow blow
Line: 2A
fast acting
If the control will not rotate to the hardstop the control may need to
be reset to default settings.
Reseting the control to defaults.
REFER TO BOTTOM OF PAGE 19 FOR DETAILS
