ED700
Low Energy
Automatic Swing Door
DORMA
6
DORMA AUTOMATICS, Inc.
924 Sherwood Drive
Toll-Free: 877-367-6211
Lake Bluff, IL 60044
Fax: 877-423-7999
DL3038-010 Rev. B
6
/08
E-mail:
Subject to change without notice
Aling
MOUNTING THE HEADER
1-
1/2
”
1-
1-
1/2
”
1-
1-
1/2
”
1-
1-
1/2
”
1-
Unit Width
(= Door width + 3”)
Unit Width
(= Door width + 3”)
1-
1/2
”
1-
Incoming 120VAC
(opposite pivot)
1-
1/2
”
1-
1/2”
PULL ARM TRACK OR DOUBLE EGRESS PAIR
Incoming 115VAC
(opposite pivot)
4 ”
1-
”
11”
1-
1/4
“
23-
1/2
”
1/2
The header should overlap the door opening 1-1/2” on each side of the frame.
If the header is shorter then the door opening the pivot side should overlap the
frame by 1-1/2” the centerline of the drive shaft should be 4” from the pivot side
of the opening in most applications.
If the header is not predrilled with mounting holes, locate and predrill at least six
mounting locations.
For outswing applications using a Push arm the header should be flush with the
bottom of the frame opening, for frames with a standard stop.
For inswinging doors using Pull Arms or Double Egress applications the header
should be located 1-1/4’ from top of the door.
The header must be plumb and level and fastened securely to the mounting
surface. Fasteners will vary with the mounting surface but the unit is supplied with
fasteners that provide adequate support for most applications. Drywall mounting
surfaces or stucco surfaces will require additional backing to support the header.
