ED700
Low Energy
Automatic Swing Door
DORMA
17
DORMA AUTOMATICS, Inc.
924 Sherwood Drive
Toll-Free: 877-367-6211
Lake Bluff, IL 60044
Fax: 877-423-7999
DL3038-010 Rev. B
6
/08
E-mail:
Subject to change without notice
Basic Set-Up
The purpose of the initial set-up is to bring the ED700
to a point where it can open the door.
Preparation for Initial set-up
BasicRequirements
•
All cables are connected.
•
Swing area is clear of obstacles
•
Mode switch in position "OFF".
• Power
connected.
Start-Up
•
Turn selector knob to “TYPE”.
•
Turn dial knob to select “Low Energy”
or “Power Assist.
The corresponding letter codes are
“LE” or “PA”.
•
Turn selector knob to “MOUNT”.
•
Turn dial knob to select “Push or Pull mount.
•
Turn selector knob to “BCK STP”.
•
Turn dial knob so that display shows “90”.
This is your back stop in degrees.
NOTE: If the door is to be set to an angle
other than 90, measure the angle the door
will open to and input that value in the step
above.
o
•
Turn selector knob to “LEARN”.
•
Turn dial knob so that display shows
“ALL”. This will cause a full Learn Cycle.
The door will stay closed for 10 seconds to
let you get into position to catch it at the
desired Back Stop.
•
Turn mode switch from “OFF” to the “ON”
position.
ON
OFF
•
The control box display will show “ALL”,
indicating that a Learn Cycle is in progress.
