![background image](http://html1.mh-extra.com/html/domo/sapphire-rxd3/sapphire-rxd3_setup-manual_2519922041.webp)
Revision: 1.0
Sapphire-RXD3 Setup Guide
Copyright © 2022 Domo Tactical Communications (DTC) Limited. All rights reserved.
Commercial in Confidence
Page 9-36
9. Appendix C – Safety and Maintenance
Note
: The following guidelines may or may not be applicable to your product. However, we would ask
that you read them to assess their relevance.
9.1 Cautions and Warnings
Area
Note
Aircraft safety
Use of this equipment on board aircraft is strictly forbidden without the
required testing and qualification for aircraft type.
Use of radio transmitter equipment in an aircraft can endanger navigation and
other systems without appropriate testing, or carry-on certification by a
competent certified body.
Cables
Connecting cables should not be positioned where they are likely to become
damaged or where they may present a trip hazard.
Electrostatic
discharge
ESD guidelines must be followed for this electrostatic sensitive device.
Enclosures
Do not remove any factory installed screws or fastenings as this may void
any warranties.
There are no functions that require the user to gain access to the interior of
the product. There are no user serviceable parts inside.
Environment
The equipment should not be used in hazardous or corrosive atmospheres.
Users are reminded of the necessity of complying with restrictions regarding
the use of radio devices in fuel depots, chemical plants and locations where
explosives are stored and/or used.
Lightning strike
There is a risk of lightning strike to antennas. The equipment should not be
assembled in an area at the time of lightning activity. Antennas should be
adequately protected from lightning strikes.
Power supply
Ensure that the power supply arrangements are adequate to meet the stated
requirements of each product. Observe all electrical safety precautions.
Risk of eye injury
Care should be taken to avoid eye contact with the antennas.
RF emissions
When using this device please ensure 20cm is maintained between your
device and your body while the device is transmitting.
Thermal control
system
If you operate this device in an enclosed space, you must ensure it has
adequate airflow to keep it cool.
If worn close to the body, care must be taken to protect the operator from
excessive temperatures.
Working at height
Observe caution when locating the device at height, for example on a mast.
Ensure the unit is well secured to prevent it falling and injuring personnel.
9.2 Repairs and Alterations
Attempted repairs, alterations, improper installations or connections may invalidate the warranty.
Please contact Technical Support if you suspect a faulty or defective component. See
Section 8.2