![background image](http://html1.mh-extra.com/html/domo/sapphire-rxd3/sapphire-rxd3_setup-manual_2519922017.webp)
Revision: 1.0
Sapphire-RXD3 Setup Guide
Copyright © 2022 Domo Tactical Communications (DTC) Limited. All rights reserved.
Commercial in Confidence
Page 5-12
5.3.2
Front Panel Touchscreen
The IP address of the Sapphire can be found and edited, if required from the front panel touchscreen.
This can be useful if the device is not connected via a DHCP server, or the IP address does not match
the subnet of the PC and the IP address settings need to be changed.
The IP address can be discovered by swiping up on the touchscreen right zone to find the
Network
Information
page. If the Ethernet cable is attached to the CTRL port, the IP address will appear
adjacent to the
Control
parameter (highlighted below). If the Ethernet cable is attached to the Stream
port, the IP address will appear adjacent to the
Stream
parameter.
The IP settings can be edited by pressing the
Current Gateway
parameter.
Note
: Some IP parameters indicated with the pencil are not currently active and are for future
development.