Revision: 1.0
Sapphire-RXD3 Setup Guide
Copyright © 2022 Domo Tactical Communications (DTC) Limited. All rights reserved.
Commercial in Confidence
Page 6-26
6.4 IP Streaming
6.4.1
IP Streaming Overview
Sapphire-RXD3 can be configured as an IP streaming input (IP1/IP2) which can be used as a source
for the ASI output, the IP streaming output or the Demux service. Setting the Demux to IP1/IP2 will
allow you to decode from the IP input.
Go to the
Config>IP Streaming
page, click the
+
button (orange circle) to create new input/output
settings. Up to two streams per input/output can be applied for redundancy or in SMPTE 2022-7
networks, see
Section 6.4.4
Once settings have been entered, click
Apply
to activate a running config and
Save
to retain.
Note
: Streaming status can be monitored in the
Status>IP Streaming
page, see
Section 6.4.5
Global Input/Output Settings
Item
Notes
Buffer Delay
IP packets can be received unevenly which causes jitter. This setting will
make the flow of data smoother by adding a delay to the input stream.
Path Differential
The path differential is a delay difference between sources when there are
different routes to the destination, for example in SMPTE 2022-7 systems,
see
Section 6.4.4
Source
Set the source of the output stream. If using IP1 or IP2, ensure the input
settings are configured.
TS per IP
The number of transport stream packets in each IP packet. Leave this at
the default value of 7 unless an advanced user.