MAR-000276_v.1.3
Chapter:
Creating New Print Files
Page 38 of 48
6.2.2 Place/Review Design
The individual layers can be reviewed by scrolling
through the “View Layer” field.
To change the view to look at the bottom layer, click
“Flip Design”.
The position of the chip on the print bed can be
changed by clicking on and dragging the chip to the
preferred position. This is useful if printing multiple
chips.
Click “Back” to change the .stl file or click “Next” to
move to the next section. See Figure 69.
Figure 69
NOTE:
If any warnings or errors are found, they will be displayed at this in this tab. Errors will be explained
further in Section 6.2.5.
.
NOTE:
to make changes to any of the layers will require the .stl file to be changed as this cannot be done
within this software.
