MAR-000276_v.1.3
Chapter:
Operating the Fluidic Factory
Page 33 of 48
Push back the Filament Tensioning Arm. Using a pair
of forceps/tweezers, remove the broken section of
Filament including any in the Print Nozzle. See Figure
57.
Thread sufficient COC through the Filament Guide to
allow it to be pushed through the hot Print Nozzle with
forceps/tweezers. See Figure 58
Take the end of the Filament and push into the Print
Nozzle. See Figure 59.
Continue to push the COC until it can be seen oozing
from the bottom of the Print Nozzle. Remove the melted
COC with forceps/tweezers. See Figure 60.
Figure 57
Figure 58
Figure 59
Figure 60
NOTICE:
The Print Nozzle will be very hot, only handle with forceps/tweezers.
