MAR-000276_v.1.3
Chapter:
Operating the Fluidic Factory
Page 27 of 48
5.4.4 Detach Print Head from printer
During normal usage, the Print Head should not be
removed. However, the Print Head does have a limited
life span and may need to be replaced depending on
the level of usage. See Figure 38.
As done during the initial installation, ensure that the
Interface Plate is above the casing of the Fluidic
Factory.
Push in the Release and Fitting Catch and pull gently
outwards at the top of the Print Head. See Figure 39.
Allow the Print Head to rotate before removing fully. See Figure 40.
Detach the Print Nozzle as described in section 5.7.
The next screen is displayed indicating that the print head can be
removed. Tap “Print Head Removed” once this has been done.
See Figure 41.
Figure 39
Figure 40
Figure 38
Figure 41
Figure 38
Figure 41
