MAR-000276_v.1.3
Chapter:
Operating the Fluidic Factory
Page 26 of 48
5.4.2 Move printer to cleaning position
Use this function;
1
When removing melted COC from the Print Nozzle.
2
When replacing the Filament Coil/Filament Guide/ Print
Nozzle assembly.
3
When re-fitting a broken filament.
See Figure 36.
5.4.3 Calibrate printer
The printer must be recalibrated following any action
that could affect the relative position between the
nozzle and the print bed.
These actions are;
1
Moving/refitting the Print Bed or Print Bed Insert.
2
Re-fitting the Print Head.
3
Replacing a Filament Coil/Print Nozzle assembly.
4
Re-attaching a broken filament.
5
Re-fitting the Gearbox.
The printer will perform a 4 point calibration with
multiple moves at each calibration point. When the
calibration is complete, the Print Head will move to the
home position. See Figure 37.
Figure 36
Figure 37
Figure 36
Figure 37
NOTICE: It is very important that the calibration is performed if as indicated. Failure to do this will result
in damage to the Fluidic Factory or poor print quality of the chips.
