Settings
111
3
Set required items
・
Register a Wi-Fi network in [Frequently used hotspot],
and the terminal will preferentially use Wi-Fi when you
are connected to the registered Wi-Fi network.
❖
About applications compatible with
Multi-connection
The application displayed by tapping [Select application] is the
Multi-connection target.
✔
INFORMATION
・
When the running application is selected in [Select
application], enabling the setting may take time.
To enable the setting immediately, end the running
application and restart the terminal.
・
Some functions may be restricted when using Wi-Fi for the
site that distinguished network connection (dmenu
→
Items in
"
お客様サポート
(Customer support)" etc.). In that case, turn
off Wi-Fi before use. On the website that does not support
multi-connection, you cannot see some part of a streaming
movie. In that case, turn off Multi-connection before use.
・
Multi-connection cannot be used in the following cases.
- In Airplane mode
- During international roaming
- Tethering in use
- VPN in connection
- Wi-Fi Direct/Miracast in connection
・
If the Wi-Fi network registered in [Frequently used hotspot]
behaves erratically, some applications that usually restrict
communications to Wi-Fi may temporarily switch over to
packet communications (LTE/3G).
・
If data amount exceeds the limit of subscribed budget plan
and transmission speed is limited, multi-connection does not
work.
◆
Wi-Fi sleep policy
Set whether to disconnect Wi-Fi when the screen of the
terminal turns off or while charging.
1
From the Home screen,
→
[Settings]
→
[Wi-Fi]
2
[Wi-Fi sleep policy]
→
Select an item
◆
Advanced Wi-Fi settings
1
From the Home screen,
→
[Settings]
→
[Wi-Fi]
→
[Advanced]
2
Set each item
Network notification :
Set whether to notify when Wi-Fi
open network is available.
・
Not available when Wi-Fi is OFF.
Avoid poor connections :
Set whether not to use Wi-Fi
network when it is unstable.
Scanning always available :
Set whether to scan Wi-Fi
network when Wi-Fi is OFF.
Wi-Fi frequency band :
Set Wi-Fi frequency band.
Install certificates :
Install certificates.
Wi-Fi Direct :
Setting steps
→
P110
Wi-Fi optimization :
Set whether to minimize battery
usage when Wi-Fi is ON.
MAC address :
Display the MAC address.
IP address :
Display the IP address.