Docomo FOMA P702iD, Manual, Page: 52 / 522

50
Co
nfirming
before Use
Se
t Ti
me
You can select whether to correct the time automatically or set it manually.
1
Clock Set time
Automatic . . . . . Corrects the date/time automatically. The setting is completed.
If the time is not automatically corrected such as when “ ” is displayed and the date/time has not been set,
the display for manually correcting the time appears. Follow step 2 to set the date/time. However, the display for
manually correcting the time does not appear when you set the date/time by Initial Setting.
Manual . . . . . . . Sets the date/time manually.
p When “Notice call cost” is set to “ON”, the display for entering your Terminal Security Code appears. Enter your Terminal
Security Code and press .
2
Enter year, month, date and time
Use to move the cursor and the numeric keys to enter numbers.
p Enter the A.D. year.
p Enter the time on the 24-hour basis.
p To enter one-digit numeral for the date and time, enter two digits beginning with “0” as in “01” to
“09”.
Information
p When an unset function is found or the software is not updated, the Initial Setting display for an unset function or the confirmation
display asking whether to update the software appears, each time you turn on the power. However if you do not insert the UIM into the
FOMA phone, the confirmation display asking whether to update the software does not appear.
p The confirmation display whether to update the software does not appear the next time you turn on the power even when software
update is not done if the date and time, Terminal Security Code, Keypad Sound, and Read Aloud Settings are all set.
p The Initial Setting display is displayed also after you execute “Initialize”.
p The completed settings are valid even when total setting is interrupted by an incoming call or canceled by pressing or midway.
p
When the clock is set and the power is automatically turned on, the Initial Setting display does not appear even if there is any unset
function.
Set Time
Setting Date and Time
Setting at purchase Automatic
< >
■ About date/time correction function
The time displayed on the FOMA phone is corrected according to the clock information obtained from the DoCoMo network.
When the date/time has not been set, the time is set when the clock information is received. If the date/time has been set, the time is
corrected when you show the Stand-by display after receiving the clock information or set “Set time” to “Automatic”. If you want to set the
time with a lag, set the time manually. When you set to “Automatic” again, turn the power off and on and then set to “Automatic”.
p You cannot correct the time while another function is working, at power on after software update, when the UIM is not inserted, or while
an animation or Flash movie set for the Stand-by display is played back. In addition, you might not be able to correct the time depending
on the radio wave conditions, the timing the FOMA phone is turned on, or the i-
α
ppli software set for the i-
α
ppli Stand-by display.
p
If the FOMA phone has not obtained any clock information, the time is not corrected by showing the Stand-by display or by setting “Set
time” to “Automatic”.
p Some few second errors might occur.