Docomo FOMA P702iD, Manual, Page: 212 / 522

210
Camer
a
Bar Code R
e
ader
You can use the outside camera to scan JAN codes and
QR codes and store them as data.
From the scanned data, you can make calls, compose
i-mode mail messages, and access Internet web pages,
and so on.
Bar Code Reader
Using Bar Code Reader
■
When scanning with Bar Code Reader
p Slide the close-up lever to “ ” and start scanning. (See page 206)
p Scan codes with the camera about 8 cm away from them.
However, slowly bring the camera close to small codes so that those
are shot large within the frame.
p Scan so that the camera is in parallel with the codes.
p
Scan so that the codes are inside the guide frame.
p After scanning, slide the close-up lever back to “ ”.
■ JAN Code
JAN Code is a bar code that denotes numerals with the vertical bars
of a different width.
You can scan 8-digit (JAN8) and 13-digit (JAN13) JAN codes.
p “4942857112597” is displayed
when the FOMA phone is used
for scanning the bar code.
■
QR Code
QR Code is one of the 2-dimensional codes that denotes data in the
vertical and horizontal directions.
Alphanumeric and other characters (kanji, katakana, pictographs)
are displayed.
Some QR codes have image or melody information.
p “ 株式会社 NTT ドコモ ” is
displayed when the FOMA
phone is used for scanning the
QR code.
< >
Guide frame
You can store up to 5 scanned codes.
You can scan up to 16 divided QR codes.
1
Bar code reader Scan code
p You can bring up the display on
the left also by selecting “Bar
code reader” of “CHG
camera-mode” from the
Function menu of the Finder
display.
p When five codes have already
been stored, the confirmation
display appears asking whether
to overwrite the oldest code.
Select “YES”.
p
You can paste the function to
the desktop when you press
( ) and select “Add
desktop icon”. (See page 167)
2
Switch to the close-up mode and fit a code to
be scanned to the guide frame and display it.
p If you can select “Bar code
reader” from the Function menu
in the Character Entry (Edit)
display, you can bring up the
display on the left also by
selecting “Bar code reader”.
p Press ( / ) to
set the photo light to “ON” or
“OFF”.
p Press ( ) and select
“Brightness”; then you can
adjust brightness to -3 (dark)
t3 (bright).
p Press to show the reduced
display, and press to
return to the former display.
Scan a Code
At Bar Code Reader
start-up
Photo light: OFF
Brightness: ± 0
Zoom: Magnified view
Bar Code Reader
Selection display
Scanning Code display