Dish Network DuoDVR ViP 622, User Manual

Page: 88 / 170

Remote Controls
79
Controlling Other Components
Setting a SAT Auto-Tune Channel
1
Make sure the remote control has been programmed to operate your TV.
2
Press and hold the TV button for three seconds until all four device mode buttons are lit.
3
Press the STAR (*) button on the remote control.
4
Using the NUMBER PAD on the remote control, enter the channel number used for
viewing (up to three digits in the range from 002 to 125), for example channel “010.”
5
Press the POUND (#) button on the remote control. The TV mode button flashes three
times to indicate programming was successful.
6
Press the SAT mode button to test the new Auto-Tune feature. The TV channel changes.
Enabling and Disabling SAT Auto-Tune
Note: SAT Auto-Tune is enabled by default; however, the channel must be set (see
Setting SAT Auto-Tune Channel).
1
Press and hold the SAT mode button for three seconds until all four mode buttons are lit.
2
Press the STAR (*) button on the remote control.