Dish Network DuoDVR ViP 622, User Manual

Page: 91 / 170

82
Controlling Other Components
Chapter 10
Setting Up Using Device Codes Scan
If the code for your device is not listed in the tables starting on page 137 or if you could not
find a code that worked for your device, use this procedure to scan the remote control’s
memory for the device code. In the instructions below, the column on the left contains the
instructions and the column on the right provides additional information.
Instructions Additional Information
1
Turn the device on.
Use the device’s front panel buttons or its remote
control.
2
Press and hold the mode button until all the
other mode buttons light up, and then
release the button. The mode button
flashes.
For example, hold the
TV
mode button until all of the
other mode buttons light. When you let go, TV will
flash.
3
For
AUX
mode only. Press 0 for TV, 1 for
VCR, or 2 for a tuner, or amplifier. Then
press the
STAR
(*) button.
This step is for programming the type of device that
will be programmed in
AUX
mode. If you’re not
programming in
AUX
mode, skip to step 4.
4
Press
POWER
.
This puts your remote in the scan mode.
5
Press the
UP
or
DOWN ARROW
repeatedly until the device turns off.
As you press the
UP
or
DOWN ARROW
, the
remote tries each code in the memory to see if it can
turn off your device. When the device turns off, you
have found a code that might work.
Note: The mode button for the device will flash
rapidly eight times when you’ve scanned all the
codes for that device.
6
Press
POUND (#)
.
The mode button flashes three times if you have
entered the code correctly, and stores the code you
found.
7
Turn the device back on and try some other
buttons to make sure they work.
Sometimes
POWER
works when other buttons
don’t. If using Limited Mode, try
VOLUME
or
MUTE
.
8
If necessary, repeat this procedure until
you’ve tried all the codes.
You may need to repeat the scan to find the best
code for your device.