Dish Network DishPro, User Manual

Page: 82 / 139

Page 80
Installation Instructions
Chapter 4
should be displayed (see example below).
If not, open the Main Menu and press 6-1-1 on the remote.
Select the 119 West option if it is not already selected.
7. Turn the dish back and forth very slowly , until the signal strength bar
turns green.This shows that you have found the signal.
Note: If you cannot find the signal, turn the dish back to the original
azimuth setting. Then, loosen both elevation bolts just enough to be
able to tilt the dish. Tilt the dish up by two degrees, and then tighten
both bolts. Now, try turning the dish back and forth again. Repeat
these steps, raising and lowering the elevation, until you find the
satellite signal.
8. Once you have a signal, turn the dish assembly back and forth very
slightly until the signal strength bar displays the strongest possible
signal strength. Tighten the mast clamp bolts. Then, loosen the
elevation bolts and adjust the elevation of the dish up and down
slightly until the signal strength bar displays a strong signal. Do not
adjust skew. Tighten all the bolts in the dish assembly so that the dish
cannot be moved.
9. Once you have the strongest possible signal, press the CANCEL
button on the remote to exit the
Point Dish/Signal
menu. The
receiver displays an
Attention
message asking whether the
installation is complete. If the answer is yes, select the
Yes
option.
The receiver will begin taking a software upgrade. You will see a
Warning
that “Vital program information will now be downloaded
into your receiver.” You will also see a status bar showing the
progress of this upgrade.
E
le
v
a
ti
o
n