Dish Network DishPro, User Manual

Page: 67 / 139

l Page 65
Installing a DishPro DISH 500 system
• If “Twin-2” is in the LNBF line, your receiver is connected to Port 2 of
the DishPro Twin LNBF. Disconnect the cable and reconnect it to
Port 1 of the LNBF, and then select
Retest to run Check Switch
again.
•If, by chance, you happened to pick up a satellite at this point, you may
see “110” or “119” in the Satellite line. If “119” shows under Dish
Input 1 , then go to step #10. If “119”shows under Dish Input 2 ,
move the dish about 9 degrees to the east, and then select Retest to
run Check Switch again. If “110” shows under Dish Input 2 ,then
go to Step #10. If “110” shows under Dish Input 1 , move your dish
about 9 degrees to the west, and then select Retest to run Check
Switch again.
10. Select OK to return to the Point Dish/Signal screen. Make sure the
check mark is next to 119 West . If not, move the highlight to
119 West and press Select. Notice the signal strength bar.This is used to
help you aim the dish by showing the strength of the signal you are
receiving. Look at the signal strength bar while you aim the dish. Or, have
one person aim the dish while another watches the signal strength or
listens to the signal tone. Don’t stand in front of the dish while you aim it,
because your body will block the satellite signal. After you adjust the aim,
let go of the dish so that it can settle back in place by itself.
Do not
change the skew setting .
11. Turn the dish back and forth very slowly, until the signal strength bar
turns green. This shows you’ve found the signal.