3590EKR, 3590EXP, 3590EXT series indicator
E-AF08_02_13.07_EN_U
9
3.2 POWER SUPPLY & START UP
- The 3590EXP and 3590EXT indicator is powered with 12Vdc voltage (8 ÷ 24 Vdc in the IO version), through an internal
adapter which converts the 100
÷
240Vac, 50÷60Hz mains voltage, and 6 Vdc, from the battery (fitted depending on the
model).
- The 3590EKR indicator is powered with 12Vdc voltage through an external adapter which converts the 100
÷
240Vac,
50÷60Hz mains voltage, and 6 Vdc, from the battery.
TO POWER
the instrument through the 240 Vac mains, or
TO RECHARGE
the battery, insert the plug and the adapter to
the 240 Vac mains socket..
To connect it to the power mains, the safety regulations must be observed, including the use of a "clean" line without
disturbances or interference caused by other electronic equipment.
Version with rechargeable battery
: The battery inside the indicator lasts about 25 hours (without the expansion board,
with 1-cell platform) and it needs a recharging time of about 12 hours.
BATTERY FEATURES
Material
LEAD
Power
4,5 Ah
Voltage
6 V
THE BATTERY MUST BE SUPPLIED DIRECTLY FROM THE MANUFACTURER.
NOTE:
it is advisable to completely recharge it (12 hours) in the first installation of the instrument; we
RECOMMEND disconnecting the battery if the instrument is not going to be used for more than 30 days.
Do not connect other equipment to the same socket as the one that the adapter is in.
Do not step on or crush the power supply cable
3.3 START UP
TO TURN ON
the instrument press the C key until the 6 status indicator LEDS turn on; then release.
The LCD display shows:
-
Initially a welcome message (settable in the TECHNICAL SET-UP,
<< LoGo >>
step,
TECH.MAN.REF.
)
while the
instrument carries out a series of checking and preheating self tests.
-
E-AF08 - XX”
name of the installed software, in which XX identifies the software language.
-
XX.YY
is the software version installed.
-
“EXECUTION AUTOZERO” the instrument carries out the "autozero at start-up” function
on all active scales:
if a weight is detected within the percentile set in the
<< Auto 0 >>
step
(TECH.MAN.REF.)
, it is cleared; if the weight is not
within this tolerance:
-
with a non approved instrument, the display shows the weight after a few instants,
-
with an approved instrument “ZErO X” is shown continuously on the LED display, (in wich X show the number of
scale where zero function is done) until the weight does not re-enter within this tolerance.
The auto zero function at start-up may be disabled in the set-up environment (only with non approved instrument); see
SEtuP >> ConFiG >> PArAM. >> Auto 0 (TECH.MAN.REF.)
.
By pressing the
2ndF
key for an instant while the version is shown in the display, the indicator will shown in this order:
XX.YY
in which XX indicates the instrument type, YY indicates the metrological software version.
XX.YY.ZZ
is the installed software version.
HH
is the installed hardware version (08).
LEGAL FOR TRADE or
HIGH RESOLUTION
if the instrument is APPROVED or UNAPPROVED, respectively.
9.XXXXX
is the the g gravity value (only with APPROVED instrument).
