Rev C April 2011
Page 4.15
Digital Projection
TITAN sx+ 3D, Dual 3D, Ultra Contrast
User Manual
4. Controlling the projector
For important information about how Input 8 is used, see
INPUT 8 in the Notes column
, and also Section 4, Overview.
Notes
The Saturation control is
available for Composite, S-
Video and Component inputs
only.
The Phase control is available
for RGB inputs only.
The Geometry settings are
NOT available for Input 8.
For all adjustments on this page
that require more than one key
to be pressed:
- after 10 seconds, if no
adjustment has been made, the
key must be pressed again
to resume adjustment.
- to end the adjustment before
10 seconds has elapsed, press
a different adjustment key, or
press the
key.
When the OSD is OFF:
- the
keys will still function,
but the controls will not be
visible on screen.
Picture settings
Press a
key, followed by
and
to adjust these picture settings:
Brightness
BRI
Contrast
CON
Saturation
SAT
Phase
PHASE
Aspect ratio
ASPECT
Geometry settings
Keystone adjustment is used to correct for distortion caused by the projector being
mounted higher or lower than the screen.
Press Keystone
KEYST,
followed by
and
to adjust the keystone correction:
Position adjustment is used for images smaller than the DMD.
Press Position
POS,
followed by
and
to select the horizontal or vertical slider,
then
and
to adjust the picture position:
•
•
•