Page 4.30
Rev C April 2011
4. Controlling the projector
Digital Projection
TITAN sx+ 3D, Dual 3D, Ultra Contrast
User Manual
For important information about how Input 8 is used, see
INPUT 8 in the Notes column
, and also Section 4, Overview.
When Input Detection is set to Custom:
Press
and
to select one of the adjustment sliders.
Press
and
to adjust the slider to match the resolution of the incoming
video signal.
Blanking
Blanking curtains can be applied to each edge of the picture.
Press
and
to select Blanking.
Press
to open the Blanking submenu.
Blanking On/Off
Press
and
to select from:
On
Off
Blanking adjust
Press
and
to select the edge to be blanked.
Press
and
to adjust the slider (0 to 200).
•
•
•
•
Notes
None of the Geometry controls
are available for Input 8.
The adjustment sliders are
available only if Input Detection
is set to Custom.
Total H Samples is available
for RGB1 and RGB2 inputs
only.
V Offset is available for DVI
input only.
WUXGA models only:
The full height of the DMD can
be used only by WUXGA and
UXGA images.
For more information, see
Screen requirements in
section 2. Installation.
Geometry Menu
Blanking
The blanking curtains will not
applied until Blanking is turned
On.
The On Screen Display will
move to the centre of the DMD
when Blanking is turned On.
Set to zero for no blanking, eg
the top edge in this example.
Geometry menu continued
