
Rev C April 2011
Page 4.13
Digital Projection
TITAN sx+ 3D, Dual 3D, Ultra Contrast
User Manual
4. Controlling the projector
For important information about how Input 8 is used, see
INPUT 8 in the Notes column
, and also Section 4, Overview.
Calibrate Focus
Press
followed by
to calibrate the lens focus mechanism.
Calibrate Zoom
Press
followed by
to calibrate the lens zoom mechanism.
Auto-detect input mode
Press
to force the projector to re-detect the input mode and apply the
default modal settings.
(see
Input modes and settings
, earlier in this section).
Source information
Press
to display the source information screen.
Input
Press
or
to change to the next input up or down the following list:
1. RGB1
2. RGB2
3. DVI (Single)
4. SDI
5. Composite Video
6. S-Video
7. Component
8. DVI (Single/Dual/Twin pixel-mapped)
Or press the numbered keys 1–8 to change directly to the input:
•
•
•
•
•
•
Notes
Each time a new lens is
fitted to the projector,
the calibration procedure
must be carried out. See
Setup menu, in Section 4.
Controlling the projector.
For more information about
input mode detection, see
earlier in this section, Input
modes and settings.
For more information about
the input connections, see
section 2. Installation, and
section 7. Appendix.
Input 8 and 3D may not be
present on some models
3D signals will be displayed
in 3D, only if 3D Enable is set
to on: see later in this section,
Setup Menu, 3D.
WUXGA models only:
3D images are possible only on
Input 8.
When an input has been
selected, the projector will
automatically detect input mode
settings such as line rate and
resolution etc.
To force the projector to re-
detect the input mode settings,
press
.