Digital Projection Mercury HD, User Manual

Page: 86 / 110

8-20
8. Using the On-Screen Menus Digital Projection
MERCURY HD
Advanced
IP Address
An IP address can be automatically assigned to this
projector by your DHCP server. If your network does not
automatically assign IP address, ask your network
administrator for an address, and then register it manually.
Automatic .... Automatically assigns an IP address to the
projector from a DHCP server.
Manual ......... Provides a space for you to register the IP
address or subnet mask number obtained
from your network administrator.
IP Address .. Set your IP address. Press to display the
software keyboard and type in 12 numeric
characters.
Subnet Mask Set your subnet mask number. Press to
display the software keyboard and type in 12
numeric characters.
Gateway ..... Set the default gateway of the network
connected to the projector. Press to
display the software keyboard and type in 12
numeric characters.
Checking this box will make the set default
route valid.
When data is sent from the LAN card, the
transfer location will be searched according
to the previously set routing information;
however, when the transfer location has not
been found as a result of the search, the data
will be sent to the device that holds the IP
address set here. The IP address that is set
here must be one that can be identified by a
search of the routing information.
DNS Configuration
.................... Type in the IP address of DNS server on the
network connected to the projector.
12 numeric characters are used.
Domain Name
.................... Type in domain name of the network
connected to the projector. Up to 60
alphanumeric characters can be used.
Network Type (required for wireless only)
Mode:
Select communication method when using wireless LAN.
Infrastructure
.................... Select this option when communicating with
one or more equipment connected to the
wireless or wired LAN network via an
access point.
802.11 Ad Hoc
.................... Select this option when using the wireless
LAN to communicate with a computer in a
one-to-one correspondence. This is a method
that meets the IEEE802.11 wireless standard.
Ad Hoc ........ Select this option when using the wireless
LAN to communicate with a computer in a
one-to-one correspondence.
Easy Connection
.................... This allows you to easily set up wireless LAN
connection. See the Software Utility
Installation section for more information.
See chapter 6 “Using the Projector in a
Network”.
SSID (Network name):
Enter an identifier (SSID) for wireless LAN. Communication
can be done only with equipment whose SSID matches
SSID for your wireless LAN. Up to 32 alphanumeric
characters can be used (Case sensitive).
NOTE: To disable SSID, select a space (null) or "ANY"(All caps).
Channel:
Set this option when selecting [802.11 Ad Hoc] or [Ad Hoc]
in [Mode].
Select a channel number from the pull-down list. The
channel must match for all wireless devices communicating
on your wireless LAN.
NOTE: Channels in the pull-down list are different depending on which
country you live in.
TX rate:
Select a wireless transmission speed. Normally leave it as
Automatic.
Try another transmission speed when the connection fails.