Digital Projection Mercury HD, User Manual

Page: 84 / 110

8-18
8. Using the On-Screen Menus Digital Projection
MERCURY HD
Disabling the Cabinet Buttons [Control Panel Key Lock]
This option turns on or off the Control Panel Key Lock
function.
NOTE:
* This Control Panel Key Lock does not affect the remote control
functions.
* When the cabinet buttons are disabled, pressing and holding the
CANCEL button for about 10 seconds will change the setting to
enable.
Lamp Settings
Lamp Mode
This feature enables you to select two modes of the lamp:
Normal and Eco. The lamp life can be extended by using the
Eco mode.
Normal Mode . This is the default setting (100%
Brightness).
Eco Mode .... Select this mode to increase the lamp life
(80% Brightness).
NOTE: The Mercury HD projector is designed to accept only one lamp
(Lamp 1), so the Lamp Select and Interval settings below will be
ignored.
Lamp Select
This feature allows you to select which lamp to be used.
NOTE: This option is not displayed in the Basic menu.
* Changes to these options will not take effect for 90 seconds
immediately after the lamp is turned off.
* The lamp cannot be turned off for 60 seconds immediately after
the lamp is turned on. Changes to these options cannot take
effect until then.
Dual ............. Select to use the two lamps at the same time
to increase brightness.
Lamp1/2 ...... Select to use one lamp of the two lamps.
(Lamp 1 on the right side and Lamp 2 on the
left side when viewed from the front)
Interval
This allows you to specify the time for switching between
the two lamps alternately. This option is available only
when “Lamp1” or “Lamp2” is selected. When Auto is
selected and one lamp has reached the end of its usable
life, the other lamp is turned on. The lamp cannot be turned
off for 60 seconds immediately after the lamp is turned on.
NOTE: This option is not displayed in the Basic menu.
Lamp Type:
The lamp type you use and its information are displayed
here.
The information displayed here is:
Light on or off.
Link Mode
Link Mode Settings Page
Selecting Standalone/Master/Slave
This feature is used for multiple projector connection. The
master projector is set to Master. The other slave
projectors are set to Slave. When not using Link mode, set
to Standalone. See page 7-5 for setting up for double
stacking in link mode.
Selecting Communication Speed [Communication Speed]
This feature sets the baud rate of the PC CONTROL port
(D-Sub 9 Pin). This is the same procedure as in “Page 6” of
“Setup”.
Enabling and Disabling Projector ID:
Each projector needs its own unique addresses when
used in serial communication mode. This is the same
procedure as in “Page 6” of “Setup”.
Copying Signals in the Entry List
Press the Entry List Copy button to copy all of the signals
recorded in the Entry List from one projector to another.