Digital Projection HIGHlite 5000GV, User Manual

Page: 83 / 94

SETTING UP FOR DOUBLE OR TRIPLE STACKING IN LINK MODE
Adjust the lens shift, zoom and focus to clearly display all three projected patterns.
If the vertical alignment of the projector(s) is incorrect, adjust the height of the
feet. If there is any keystone distortion, use Keystone adjustment to correct and
save the settings on each projector.
SIGNAL DATA PREPARATION
When stacking multiple projectors each projector should be configured to display
the input image in exactly the same manner. This requires configuring the master
projector for each input signal type, adjusting the image and copying it to the slave
projectors using a PC card as follows:
1. Choose one projector to be the master projector and turn it on.
2. Display all the desired input signals adjusting each signal to provide an optimum
image and place the master projector in standby mode.
3. Remove the PC Card slot decorative panel and insert a PC card into the slot .
4. Press and hold CANCEL, then press POWER on the rear panel of the master
projector. The POWER indicator will change to steady green and the PC Card
Access indicator will start flashing. The data will be automatically stored on the
PC card and the POWER indicator will change to amber.
5. Remove the PC card from the slot of the master projector and insert it into the
slot of a slave projector.
Since data in the slave projectors will be lost at this time, make backup copies of
them before proceeding.
D—5
Advanced User Information
ADVANCED
LBV00063; Revision A - 01/02/2000
✍
✍