DIGITAL-LOGIC MICROSPACE MSEP800, Technical User'S Manual

Page: 33 / 140

DIGITAL-LOGIC AG
MSEP800 Manual V1.0G
33
4 D
ETAILED
S
YSTEM
D
ESCRIPTION
This system has a system configuration based on the ISA and PCI architecture. Read carefully all informa-
tion since this product is a very new computertechnology.
4.1 Power Supply Requirements
This product includes allready a widerange powersupply. So the supply voltage may be in the
range of 8V up to 30V DC.
The recommended supplyinput is 12Volt or 24Volt DC. We recommend to protect the system
with a fuse.
4.1.1 Minimum Power-OFF time:
If the power is switched off, the off period must be minimum 10sec !
All capacitors must be fully discharged befor a new power on is performed.
4.2 Power Requirements
The power is connected through the PC/104 power connector; or the separate power connector on the
board. The supply uses only the +5 Volts and ground connection.
Warning: Make sure that the power plug is wired correctly before supplying power to the
board ! A built-in diode protects the board against reverse polarity.
Testenvironment for powerconsumption measurement:
Peripheries:
Harddisk Hitachi Mod-HTS424020M9AT00 20Gb
Monitor Eizo Flexscan F340i.W
PS/2-KB Logitech Mod-iTouch Keyboard
PS/2-MS Logitech Mod-M-CAA43
Software:
MS-DOS V6.22
WinXP
Current consumption @ 10/19/24Volt supply at –40°C /+25°C/+85°C
Mode Memory Voltage: -30 °C +25°C +85 °C
MSEP800 - 500MHz [mA] [mA] [mA]
Win2000: Desktop 1GB 10V 960
Win2000: Desktop 1GB 19V 520
Win2000: Desktop 1GB 24V 420