3.1.3.5 Inserting a Tape Cartridge
Before you use the tape drive, make sure your system is turned on. During
power-up:
• The TK70 drive runs self-tests that last a few seconds. All three lights
(orange, yellow, and green) come on momentarily, then the yellow (Tape in
Use) light blinks during the self-tests.
• At the end of the tests, the yellow light goes off and the green (Operate
Handle) light comes on, accompanied by a short beep.
The green light and the beep indicate that you can move the cartridge release
handle.
CAUTION
Move the handle only when the green indicator light is on. Moving the
handle while the yellow light is on can damage the drive. If all three
lights blink rapidly at any time, a fault condition exists. Press the Unload
button once. If the fault clears, the tape unloads. The yellow light blinks
during unloading, then the green light comes on. If the fault does not
clear, the three lights continue to flash. Do not use the drive or remove
the cartridge. Call your Digital service representative.
Use the following procedure to insert a tape cartridge.
3–30 Operating the System Options
