3.1.2.5 Inserting a Tape Cartridge in TF-Series Drive
Before you use the tape drive, make sure your system is turned on. During
power-up, the drive runs self-tests that last a few seconds. All four indicator
lights come on momentarily, then the yellow (Tape in Use) light blinks during the
self-tests. At the end of the tests, the yellow light goes off and the green (Operate
Handle) light comes on, accompanied by a short beep. The green light and the
beep indicate that you can move the cartridge handle.
CAUTION
Move the handle only when the green indicator light is on. Moving the
handle when the yellow indicator light is on can damage the drive.
If all four indicators blink rapidly at any time, a fault condition exists.
Press the Unload button once. If the fault is cleared, the tape unloads.
The yellow indicator blinks during unloading, then the green indicator
comes on. If the fault is not cleared, the four indicators continue to flash.
Do not attempt to use the drive or to remove the cartridge. Call your
Digital service representative.
Operating the System Options 3–17
