Chapter 4: Completing Your Configuration Set Up Under Windows NT
EK
−
SMRAA
−
IG. A01
4
−
3
Figure 4
−−
2 How the hszdisk entry appears when it fails to load.
3. Close the Event Viewer when you finish verifying hszdisk.sys.
4.1.3
Completing a New RAID Array Configuration
The steps listed in this section are necessary to complete your RAID Array installation. This
section describes how to use Disk Administrator to complete a new configuration under
Windows NT. The instructions listed here are summary in nature. For additional information,
refer to your Windows NT documentation.
NOTE
To safeguard critical data, backup your system using normal
backup procedures before altering device partitions.
To begin, run
Disk Administrator
from within Windows NT by performing the following
steps:
1. Select
Program Manager
2. Select
Administrative Tools
3. Select
Disk Administrator