Getting Started – RAID Array 310 for Windows NT – Intel
1–8
EK–SMRAA–IG. A01
Figure 1
–6 StorageWorks SCSI Bus Port and SCSI ID Assignment
1.9
Charging the RAID Array Controller Write-back Cache Batteries
The Write-back Cache Module in the controller contains a battery that may have discharged
since the time it was factory-installed.
CAUTION
Loss of power before the write-back cache battery is fully charged
may result in the loss of data.
We recommend that you take this opportunity now to recharge the batteries. This is accom-
plished by doing the following:
Apply power to the controller, by pressing the power switch on the front of the subsystem.
You should hear a momentary audible tone (beep), and see the indicator LEDs illuminate. In
addition, a green LED on the front panel of the subsystem should flash at approximately 1
Hz. Power on the subsystem for a minimum of 6 hours. The battery will be fully re-charged
in the time specified.
