Chapter 1. Unpacking and Setting Up Your RAID Array 310 Subsystem Components
EK–SMRAA–IG. A01
1–7
Figure 1
–5 Subsystem CLI Serial Connector
1.8
Installing Disk SBBs in the RAID Array 310 Enclosure
You may install the disk drive SBBs into the RAID Array 310 enclosure at this time. To in-
stall an SBB, hold it in both hands, insert it into the guide slots, and firmly push it into the
shelf until the mounting tabs snap in place. Figure 1–6 shows a layout of the SCSI bus ports
and corresponding SCSI ID assignments in the enclosure. Refer to Chapter 3, Configuration
Rules and Restrictions, included with your system.
